The short answer
Eligible FTTN and FTTC premises can get nbn full fibre installed alongside the existing connection, usually by ordering an eligible plan through a participating provider. A technician fits a new fibre connection box. Your old service keeps running until it is cancelled, so confirm the new one works, including the phones, before you switch everything over.
Is your business eligible?
nbn’s full fibre upgrades are for premises currently served by Fibre to the Node (FTTN) or Fibre to the Curb (FTTC). The fibre is extended to your building and a new connection box is fitted inside. Eligibility is decided address by address.
- The premises
FTTN or FTTC, in an upgrade area
nbn says eligible businesses on FTTN and FTTC can upgrade, including premises nbn designates as a “simple premises”. Complex buildings may still be possible but can cost more.
- The plan
An eligible speed tier
The upgrade is usually tied to ordering a plan on an eligible wholesale speed tier through a participating provider. The rules have been changing. In December 2025 nbn said it planned to remove the high-speed plan requirement for some FTTC upgrades from July 2026. Check what applies to your address.
- Business grade
Extra qualifying products
nbn notes a business-grade installation needs additional qualifying products, such as nbn Business Service. Conditions, eligibility and costs vary by provider, so ask yours in writing.
nbn’s business fibre wholesale tiers show why businesses upgrade: the upload side is far higher than on copper.
- 250/100Wholesale download / upload in Mbps on nbn’s business fibre tiernbn business fibre
- 500/200Mbps, with nbn’s Business Service Pro included as standardnbn business fibre
- 1000/400Mbps, close to 1Gbps down and 400Mbps upnbn business fibre
Wholesale speeds are the maximum delivered to your provider, not a guaranteed speed at your desk. Plans and prices are set by each provider.
What the install involves
The new fibre service is installed alongside your existing one. Your current internet keeps working until you choose to cancel it, which is what makes a calm switch possible.
- Order
Address check and order
- Your provider checks the address and places the upgrade order with an eligible plan.
- Rented or strata premises: get the owner’s or body corporate’s approval early. It is the most common delay.
- Visit 1
Fibre to the building
- nbn runs fibre from the street to the outside of the building. This may need a path through a driveway, garden or existing conduit.
- Agree where it enters before the day.
- Visit 2 (sometimes the same day)
The box inside
- A technician fits the fibre connection box (the network termination device) inside, near a power point.
- One or more visits are normal. One wholesale provider’s terms give indicative targets of 27 business days in urban areas and 31 in rural areas, not guaranteed.
- Go live
New service runs beside the old
- Your modem moves to the new box and is set up for fibre.
- Some providers start billing the new service soon after installation, even if you have not moved across, so plan the switch for that week.
- Switch
Test, then cancel the old service
- Test everything on the checklist below first.
- Then ask the old provider to cancel the old plan so you do not pay for both.
Where the box goes, and why it matters
The fibre box stays where it is put. Choose its spot with the same care as the comms cabinet, because every network cable and the phones will follow it.
| Check | Good spot | Avoid |
|---|---|---|
| Near your network gear | Inside or beside the comms cabinet or where the modem lives now | A far wall that needs a long cable run back to the cabinet |
| Power | A dedicated power point, ideally on a small UPS | A shared power board under a desk that gets switched off |
| Air | Ventilated, room temperature | A closed cupboard with the hot water system or a server |
| Access | Reachable without moving stock or furniture | Behind shelving or inside a locked tenant area |
Power, phones and the modem
- Power
The fibre box needs mains power
No power, no internet, no internet phones. nbn says a battery backup can be ordered through your provider for the fibre box, lasting about five hours, but other powered devices need their own backup. See Will your business phones work in a power or internet outage?.
- Modem
The connection changes
On FTTN the modem plugs into the phone socket. On fibre it connects to the box with a network cable and uses different settings. Most modems support both, but the settings must be changed.
- Phones
The phones fail first
Any modem change can break phone settings such as port forwarding. Test calls before anything else. See Changing your modem or internet provider? The things that break, and how to prevent them.
After the install: test before you cancel
Do not cancel the old service until all of these pass
0 of 9 doneQuestions to ask your provider
Is my exact address eligible, and on which plans?
Is any of the installation chargeable for this building?
Standard installations and non-standard work can be treated differently.
Is there a minimum term, and what happens if I change plans?
When does billing for the new service start?
Will my static IP, phone numbers and any business support options carry over?
Who sets up the modem, and who tests the phones on the day?
Comparing plans? Size your upload need first with How much internet does your business need? A bandwidth calculator that counts upload. If you need more than a business nbn plan offers, see Enterprise Ethernet explained: what it does for your business, and when it is worth it.
Sources and further reading
- nbn: Upgrade your business to nbn full fibre
- nbn media statement: relaxing the FTTC to FTTP eligibility requirement (15 Dec 2025)
- Vocus: Fibre Connect upgrade offer terms (effective 16 April 2026)
- nbn: What happens in a power blackout
Checked 12 November 2026. Product menus and provider rules change; check the linked source if something looks different.